MAX20086 Dual/Quad Camera Power Protectors

Product Details

The MAX20086MAX20089 dual/quad camera power protector ICs deliver up to 600mA load current to each of their four output channels. Each output is individually protected from short-to-battery, short-to-ground, and overcurrent conditions. The ICs operate from a 3V to 5.5V supply and with a 3V to 15V camera supply. The input-to-output voltage drop is only 110mV (typ) at 300mA.

The ICs provide an enable input and I2C interface to read the diagnostic status of the device. An on-board ADC enables reading of the current through each switch. The ASIL B- and ASIL D-compliant versions include support for reading an additional seven diagnostic measurements through the ADC, ensuring high-fault coverage.

The MAX20086MAX20089 include overtemperature shutdown and overcurrent limiting on each output channel separately. All devices are designed to operate from -40°C to +125°C ambient temperature.


  • Power-over-Coax for Radar and Camera Modules
  • Surround-View Camera ECU

Features and Benefits

  • Small Solution
    • Up to Four 600mA Protection Switches
    • 3V to 15V Input Supply
    • 3V to 5.5V Device Supply
    • 26V Short-to-Battery Isolation
    • Adjustable Current Limit (100mA to 600mA)
    • Parallel Multiple Channels for Higher Current
    • Selectable I2C Addresses
    • Small (4mm × 4mm) 20-Pin SW TQFN Package
  • Precision
    • ±8% Current-Limit Accuracy
    • 0.5ms Soft-Start
    • 0.25ms Soft-Shutdown
    • 0.3µA Shutdown Current
    • 110mV Drop at 300mA
  • Designed for Safety Applications
    • ASIL B/D Compliant
    • Short to VBAT/GND Diagnostics
    • Differential Output Over/Undervoltage Diagnostics
    • Input Over/Undervoltage Diagnostics
    • Individual 8-Bit Current, Output Voltage, and Supply Readings Over I2C
    • Autoretry on Fault
  • AEC-Q100, -40°C to +125°C